Step 1: Remove the 2 gold control port
screws. Replace the top cover on the PS2 to avoid the control port
dangling, possibly damaging the cable.
Step 2: Remove the 2 gold screws that
hold down the power supply and the expansion bay cage.
Step 3: Lift up the right half of the
power supply. Lift up and out the expansion bay cage.
Step 4: Now you have exposed the slot to
re-insert your reset/eject cable. This shows a white slot. Some PS2s
have a brown clip that holds the Reset/Eject cable in place.
Important: Reverse this order to put your
system back together. It is VERY Important that you tape down the
reset/eject cable onto the top of your DVD drive again. Otherwise it may
find itself in a screw hole and you can end up putting a screw right through it.